|
Offshore Fishing Boats and Gear
Boats and Boat Equipment
Boating
on Lake Erie is not like boating on any other body of water in
Pennsylvania. The lake is vast and can be deadly. If you do not
have an appropriate boat, you will be risking your life boating
on the lake. Deep V-hull boats are the norm on the lake. The deep
hull gives the boat stability and the ability to take the waves.
Tri-hulls have too much bottom surface, cannot take the waves
well, and its occupants will get pounded by the waves. Pontoon
boats and typical shallow "bass boats" are not appropriate any
distance from shore. Any boat under 16 feet in length is also
risky to take far from shore.
If
you plan to fish in the deep waters, at least a 50 horsepower
motor is recommended. Many boats which troll on the lake have
two motors; a large motor for getting to and from the fishing
waters, and a small, 5 or 10 horsepower long shaft pull start
outboard motor for trolling. This combination has at least two
advantages. First, it saves wear on the main motor, which can
foul after extended trolling at slow speeds. Second, it provides
a safety net - if the main motor dies (or the batteries die and
will not start the main motor), the trolling motor can bring you
back (albeit slowly). Many who do not have a separate trolling
motor use a trolling plate on the main motor to maintain a slow
trolling speed. Many lake boats also have two batteries. Two batteries
give you added protection that you can get your big motor started
to get you home. Cranking the key and hearing the motor slowly
turn then stop due to a dead battery is a very unpleasant experience
when you are miles from shore.
There
are three common pieces of equipment used on lake boats that are
highly recommended: a marine radio, a fish/depth finder, and a
navigational aid consisting of either a loran or a GPS unit. The
marine radio is an important safety item to call for help if you
or other boaters might need it. The coast guard, with a station
located just inside the channel to Presque Isle Bay, monitors
channel 16. A radio can also be used to call for a marine towing
service if you need one. Anglers use channels 68 and 69 heavily
for routine communications while fishing.
A fish
finder, although not necessary for safety, is very helpful for
locating fish and structure in what can seem like an endless expanse
on the lake.
A navigational
aid is a very important safety aid, as well as an asset to successful
fishing. Until recently, most boats on the lake were equipped
with a loran, which is a land based radio wave positioning system.
It is relatively accurate and can return you to port or your fishing
hot spot with ease. Lorans use their own numbering system rather
than longitude and latitude coordinates. Anglers using lorans
often describe their position as "28880.1 on the top, 58357.7
on the bottom," referring to the top and bottom loran coordinates
of their location. Lorans are being replaced by the GPS, and the
loran transmitters will be turned off sooner or later, rendering
the loran useless. The GPS, or global positioning system, is an
even more accurate, satellite based positioning system. It displays
location using longitude and latitude coordinates. Like the loran,
the GPS can store numerous "way points", such as home port and
fishing hot spots. You can then call up a way point, and the GPS
will tell you which direction to go to get there. It also provides
much more information, such as how fast you are going, how long
it will take you to get to your destination, how far off course
you have gone, etc.
Finding
your way on the lake can be difficult. If you motor out to deep
water with only a compass, then troll about for several hours,
using only a compass to return to port will be difficult and very
inaccurate. If the waves suddenly pick up and you have to return
quickly and directly, or if a fog bank rolls in and you cannot
see more than 20 feet from your bow, a loran or a GPS will be
worth every cent you paid to get you home safely.
Many
boats equipped for fishing on Lake Erie also have a planer board
mast (to run planer boards), two or more downriggers (manual or
electric), multiple stand-up rod holders, a sizable cooler with
ice, and a large, long handled net. Other items to consider taking
on your boat include a map of the lake, a first aid kit, binoculars,
sun glasses and sun screen (there is no shade on the lake), rain
gear, an extra jacket, a good anchor with plenty of line, sea
sickness medicine, hook extractors and a fish "club."
Remember
that all boats on Lake Erie 16 feet in length and over must carry
visual distress signals. All boats require visual distress signals
if on the water between sunset and sunrise. Before leaving for
a trip on the lake, review the boating regulations and your gear
to be certain you have all the necessary equipment and leave a
float plan.
Lake
Rods, Reels and Line
Most
anglers use similar rods and reels on the lake for trolling or
drift fishing for all the larger species. (Perch fishing uses
much smaller rods and reels and lighter line). The common rod
is a relatively long (about 8 feet) trolling rod in the 10 to
20 pound line class. If you plan to use a diver, especially a
dipsey diver, use a diver rod with a strong lower section that
can withstand the strong pull of the diver. Many regular rods
will break just above the handle if used with a diver.
By
far the most common reel for trolling is the level wind reel.
The Penn 310 and 320 are still popular. Reels with line counters
are becoming popular. These reels allow you to more accurately
set lines on divers and planer boards.
Line
used for trolling varies. The most common lines used are from
12 pound to 17 pound test. Light lining is becoming more popular,
but is still not widespread. Twenty pound line is not uncommon,
especially for use with divers.
Trolling and Trolling Methods
Flatlining
Flatlining is the
simplest of the trolling methods. It consists of sending a lure
out as you troll away. Once the lure reaches the desired distance
behind the boat, close the bail and let the lure pull behind the
boat. Line counter reels are very helpful for determining how
far back the lure is running. The depth of the lure can be controlled
by the type of lure used. Deep diving lures, equipped with large
lips, can be pulled to depths of 15 feet or more.
Planer Boards
Planer boards are
used to fish close to the surface, but away from the noise and
disturbance of the boat. A planer board mast, planer boards and
releases are all necessary. A typical mast has two lines and two
spools, one for each side. The planer boards (usually made of
redwood) are hooked to the end of the line connected to the mast.
As the board is let out on the water, it "planes" away from the
boat. One board planes right, the other left. The boards often
are equipped with a flag so they can be located while in use.
Once the boards
are out, each line is set. A lure is sent off the boat and allowed
to drift the desired distance it will be fished behind the planer
board line. Once the desired distance is obtained, the bail is
closed. A release is connected to the planer board line. One end
of the release slides along the planer board line, and the other
end has a rubber clip for grabbing the fishing line. Some anglers
use rubber bands tied around the line, which are then placed into
the release. The line from the rod is pinched on the release clip,
the bail is opened, and the line begins to slide down the planer
board line and away from the boat. Once the line is the desired
distance down the planer board line and away from the boat, the
bail is again closed and the rod is put in an upright holder.
While the rod is connected to the planer board line, the fishing
line goes sideways to the planer board line release, then back
behind the boat. When a fish strikes, the line releases and the
line whips to a position straight back from the boat.
Planer boards are
popular for walleye fishing early in the summer, when the water
is colder and the fish are closer to the surface. It allows you
to put multiple lines out on both sides of the boat without tangling
them as easily as you would if they were all straight behind the
boat. Planer boards are also used to troll for smallmouth and
to troll for steelhead close to shore in the fall. Use of planer
boards for walleye fishing has been diminishing in recent years,
and been replaced in popularity with Dipsy Divers.
Divers
Divers are gaining
in popularity on Lake Erie. They are somewhere between flatlining
or using planer boards, and using downriggers. The diver takes
the lure down deeper than a flat line, but cannot reach the depths
or the depth accuracy of a downrigger. Divers do, though, have
the ability to get the lure down a considerable depth, and get
the lure away from the boat. Divers often plane to one side, allowing
multiple lines to be fished across the back and sides of the boat.
They are also less expensive than downriggers.
Divers come in a
variety of styles. The Dipsey Diver is the most popular. Other
divers include the Fish Seeker and the Jons Diver. With most divers,
a short piece of line is prepared with a snap swivel on each end.
One end is connected to the diver, and the lure is attached to
the other end. The length of this line will determine the distance
the lure will run behind the diver. The end of the line from the
reel is connected to the front of the diver. The diver usually
has a release that must be closed so the unit dives down when
set into the water. The rig is then sent over and allowed to dive
down, back, and sometimes to the side. Some divers can be set
to adjust the angle they will plane to the side of the boat, allowing
divers to be set to plane right and left behind the boat. The
depth they dive is determined by how far they are let out behind
the boat. For this reason, a line counter helps to return the
diver in the same general location.
When a fish strikes
the lure, the release is opened and the diver planes toward the
surface.
Some anglers use
divers and planer boards. The lines are set out on divers, the
sent out the planer board line to get them further apart. This
allows fishing a multitude of lines both down and away from the
boat.
Downriggers
Downriggers are
used for accurately getting a lure to any depth. This requires
a downrigger and a downrigger weight with an attached release.
Downriggers come in both manual and electric models. The electric
models wind the weight up and down automatically. The downrigger
has a wire line on a spool, a swivel base, a mast which extends
the wire over the water, and a heavy snap swivel on the end of
the wire line. Manual models have a handle to crank the wire line
up and down. A large downrigger weight is connected to the swivel
on the end of the wire line. The weight has a release connected
to it. The release has a rubber clip for grabbing the fishing
line.
The fishing line
and lure are sent over the boat and allowed to run out the distance
you want the lure to travel behind the release. The bail is then
closed. The downrigger mast and weight are swung toward the boat.
The fishing line is then connected to the release on the weight.
The bail on the fishing reel is opened, the weight is put over
the water, and the steel downrigger line is let out. The weight,
with the fishing line attached to the release, begins to drop
nearly straight down. The downrigger has a depth counter so you
can see how far it is going down. When the desired depth is obtained,
the downrigger is stopped, and the bail on the fishing line is
closed. The rod is put into the holder attached to the downrigger.
The rod will be bent over hard, since the line is connected to
the release which is nearly straight down below the boat. The
line should be tight, but no so tight that it pulls the line out
of the release.
When a fish strikes,
it pulls the line out of the release. Since there is considerable
tension on the rod when connected to the release, the downrigger
"sets the hook" when it releases. The rod suddenly stands up when
a fish is on.
Multiple lines can
be stacked on a single downrigger line. To stack lines, one fishing
line is connected to the release on the weight in the normal manner.
Let the downrigger down the distance you want the two lines to
be apart. Once this distance is reached, stop the downrigger and
close the bail on the first reel. Attached the stacker, which
consists of a wire line with a safety clip (put over the downrigger
line) and a rubber release on each end. One release attaches to
the steel downrigger line. The second release is attached to the
second fishing line you wish fish off the downrigger. You must
then open the bails on both reels, and send the rig down the remaining
distance. Doing this single-handedly is nearly impossible.
Weighted spinners (willow leafs)
The willow leaf
spinner - nightcrawler harness is one of the most popular rigs
used on Lake Erie for taking walleye. This rig normally consists
of two relatively large hooks tied one atop the other, with a
willow blade clasped above the hooks, on a longer heavy line with
a loop at the top end. A nightcrawler is put through both hooks.
An elliptical weight with a ring on each end is connected to the
top of the rig through the loop in the line at the upper end of
the rig. A swivel on the end of the fishing line is connected
to the other end of the weight. As it moves through the water,
the willow leaf spins. All the local bait shops carry these rigs,
which are often called a "walleye harness" or a "crawler
harness."
The rig is fished
by trolling or drifting. It is often fished near the bottom. In
water of 60 feet or more, a four ounce weight may be necessary
to get the rig to the bottom. Let the line out until you feel
the weight hit the bottom (it is not as easy as it sounds). Close
the bail, then wind the line up at least a few cranks. Either
hold the rod or put it in a rod holder.
This rig can also
be fished part way down, or with a weight that will not get it
to the bottom. It can also be fished on a downrigger or planer
without any weight. It can also be fished with a small weight
(enough to keep it down) from planer boards.
|
|